Sanyo Sanyo DP19649 P19649-02 N7SE [SM] free download

File name Sanyo_DP19649_P19649-02_N7SE_[SM].pdf

SANYO Factory Code N7SE Service Reference NO. 609 DP19649 SERVICE MANUAL 18.5" HDTV LCD ORIGINAL MFR'S VERSION C Design and specifications are subject to change without notice. SERVICING NOTICES ON CHECKING 1. KEEP THE NOTICES 6. PERFORM A SAFETY CHECK AFTER As for the places which need special attentions, SERVICING they are indicated with the labels or seals on the Confirm that the screws, parts and wiring which cabinet, chassis and parts. Make sure to keep the were removed in order to service are put in the indications and notices in the operation manual. original positions, or whether there are the portions which are deteriorated around the 2. AVOID AN ELECTRIC SHOCK serviced places serviced or not. Check the There is a high voltage part inside. Avoid an insulation between the antenna terminal or electric shock while the electric current is external metal and the AC cord plug blades. flowing. And be sure the safety of that. 3. USE THE DESIGNATED PARTS (INSULATION CHECK PROCEDURE) The parts in this equipment have the specific 1. Unplug the plug from the AC outlet. characters of incombustibility and withstand 2. Remove the antenna terminal on TV and turn voltage for safety. Therefore, the part which is on the TV. replaced should be used the part which has 3. Insulation resistance between the cord plug the same character. terminals and the eternal exposure metal Especially as to the important parts for safety [Note 2] should be more than 1M ohm by which is indicated in the circuit diagram or the using the 500V insulation resistance meter table of parts as a mark, the designated [Note 1]. parts must be used. 4. If the insulation resistance is less than 1M ohm, the inspection repair should be 4. BE CAREFUL WITH THE required. LCD PANEL [Note 1] Avoid a shock to the panel while servicing. If you have not the 500V insulation Take enough care to deal with it. resistance meter, use a Tester. 5. PUT PARTS AND WIRES IN THE [Note 2] ORIGINAL POSITION AFTER External exposure metal: Antenna terminal